number of downloads : ?
File
language
jpn
Author
Boleslaw, Porankiewicz
Tanaka, Chiaki
Description
A study was conducted to test the wear on a cutting edge when machining melamine coated particle boards. This study utilized particle boards made by 3 different producers. In each of the 3 cases there was a high degree of dissimilarity in the wear of the cutting edge after processing. The following factors were found to have a profound effect on tool wear: sand content, weighted average sand, cutting path, cutting speed and the sharpness angle. No impact on tool wear was found with regard to resrn and filler content in melamine film and micro-hardness of melamine film.
Journal Title
Bulletin of the Faculty of Agriculture, Shimane University
Volume
27
Start Page
57
End Page
63
ISSN
0370940X
Published Date
1993-12-20
NCID
AN00108015
Publisher
島根大学農学部
Publisher Aalternative
Shimane University, Faculty of Agriculture
NII Type
Departmental Bulletin Paper
OAI-PMH Set
Faculty of Life and Environmental Science
他の一覧
このエントリーをはてなブックマークに追加