The Workability of Melamine Coated Particle Boards

島根大学農学部研究報告 Volume 27 Page 57-63 published_at 1993-12-20
アクセス数 : 989
ダウンロード数 : 69

今月のアクセス数 : 0
今月のダウンロード数 : 0
File
d0030027n009.pdf 759 KB エンバーゴ : 2001-10-08
Title
The Workability of Melamine Coated Particle Boards
Creator
Boleslaw Porankiewicz
Tanaka Chiaki
Source Title
島根大学農学部研究報告
Bulletin of the Faculty of Agriculture, Shimane University
Volume 27
Start Page 57
End Page 63
Journal Identifire
ISSN 0370940X
Descriptions
A study was conducted to test the wear on a cutting edge when machining melamine coated particle boards. This study utilized particle boards made by 3 different producers. In each of the 3 cases there was a high degree of dissimilarity in the wear of the cutting edge after processing. The following factors were found to have a profound effect on tool wear: sand content, weighted average sand, cutting path, cutting speed and the sharpness angle. No impact on tool wear was found with regard to resrn and filler content in melamine film and micro-hardness of melamine film.
Language
jpn
Resource Type departmental bulletin paper
Publisher
島根大学農学部
Shimane University, Faculty of Agriculture
Date of Issued 1993-12-20
Access Rights open access
Relation
[NCID] AN00108015