島根農科大学
ISSN:0559-8311
ダウンロード数 : ? 件
この文献の参照には次のURLをご利用ください : https://ir.lib.shimane-u.ac.jp/4017
島根農科大学研究報告 12
1964-01-10 発行
南方産木材の加工特性(I) : Lauan材からのVeneer収量について
The Technologic Properties of Wood imported from the Southen Asia(I) : On the Yield Rate of Lauan Block by Rotary-Cutting
桜井 敏夫
山根 啓義
ファイル
内容記述（抄録等）
The main purpose of this nvestigation was to find the yield rate of the Lauan log(block) used for the plywood manufacture. The measurements were doun under the practical onditions. (Osaka, Tootori, Shimane district)
The Obtained results are shown in Fig. 1 , 2. From these results it is considered that the yield rate are as follows:
face Veneer 40-50 %
core 10 %
The relations between diameter of block and the rate are shown in Fig. 3.
The rate should be droped by the eccentricity of set (Rotary chuck and block center), and these tendencies colculated by a experimental formura VI are shown in Fig. 5.
The Obtained results are shown in Fig. 1 , 2. From these results it is considered that the yield rate are as follows:
face Veneer 40-50 %
core 10 %
The relations between diameter of block and the rate are shown in Fig. 3.
The rate should be droped by the eccentricity of set (Rotary chuck and block center), and these tendencies colculated by a experimental formura VI are shown in Fig. 5.
About This Article
Other Article