ダウンロード数 : ?
タイトルヨミ
モクシツ ザリョウ ノ カイリョウ ニ カンスル ケンキュウ ダイ15ホウ ヒカリジュウゴウホウ ニヨル モクフン プラスチック フクゴウタイ ノ セイケイ ト ソノ セイシツ
日本語以外のタイトル
Studies on the Improvement of Wooden Materials(XV) : Molding of Photopolymerized Wood Flour-Plastic Combination and It's Properties
ファイル
言語
日本語
著者
往西 弘次
城代 進
後藤 輝男
内容記述(抄録等)
The molding of the wood flour-plastic combination which was produced by means of photopolymerization and the properties of molded boards were inestigated.
The results obtained are as follows :
1) It was possible to produce the molded board under these optimum conditions of molding time : 30 min, molding pressure : 100kg/<cm>^2 and molding temperature : 180℃.
2) The modulus of rupture ande elasticity in bending of molded board increased along with increasing of molding temperature and specific gravity of molded board.
The bending properties of molded board contained the filler of polypropylene calcium carbonate, glass fiber or saw-dust polymer decreased in comparison with those of the control board.
3) The Brinell hardness of molded board increased along with increasing of molding temperature and the specific gravity of molded board. It was observed that the Brinell hardness of molded board was higher than that of radial section on wood and lower than that of cross section.
4) The moisture uptake and the swelling of thickness of molded board were remarkably decreased in comparison with those of wood.
5) The softeinng temperature of molded board surface was almost the range of 120 to 130℃, but on the molded board contained polypropylene or saw-dust polymer as filler, the softening temperature reached above 170℃.
掲載誌名
島根大学農学部研究報告
9
開始ページ
68
終了ページ
72
ISSN
0370940X
発行日
1975-12-15
NCID
AN00108015
出版者
島根大学農学部
出版者別表記
Shimane University, Faculty of Agriculture
資料タイプ
紀要論文
部局
生物資源科学部
他の一覧