ダウンロード数 : ?
タイトルヨミ
テッコウセキ ヨウカイ カンゲン プロセス ニオケル メタル セイブン ノ キョドウ ト ソレヲ セイギョスル ジョウケン
タイトル別表記
Behaviour of Metal Compositions and Conditions Determing Them in Smelting Reduction of lron Ore
ファイル
言語
日本語
著者
小川 雄司
片山 裕之
内容記述(抄録等)
The behavior of impurities (carbon, phosphorus, sulphur and nitrogen) in a smelting reduction process was investrgated by 5 ton and 100 ton scale experiments.
(1) In the case of almost carbon-saturated iron, the phosphorus content in the metal can be reduced below 0.02% (min.0.004%) by controlling the (T. Fe) content in the slag above 4-5% and the bath temperature below 1450℃.
(2) More than 60% of input sulphur evaporated during smelting reduction, most of which were captured into the dust as FeS. The distribution of the remaining sulphur between slag and metal can be expressed as follows.
log (S)/[S] = -3032/T-0.343 log (% T. Fe)
+ 0.660{[(% CaO) + (% MgO)]/[(% SiO_2)+ (% Al_2O_3)]} + 1.431
(3) The carbon content in the metal depends on the sort of carbonaceous materials and operational conditions such as the intensity of bottom stirring. The change in carbon content can be explained by the balance between carburization (which is determined by the distribution of carbonaceous materials and metal droplets in the slag layer) and decarburization (that is, reduction rate of iron ore by carbon in the metal).
(4) In order to improve the removal of impurities in the smelting reduction process, it is desirable to operate at more than 3% of carbon content. There are two typical operational methods, one of which is concentrated in dephosphorization and another is in desulphurization.
掲載誌名
島根大学総合理工学部紀要. シリーズA
30
開始ページ
149
終了ページ
160
ISSN
13427113
発行日
1997-03-25
NCID
AA11157087
出版者
島根大学総合理工学部
出版者別表記
Interdisciplinary Faculty of Science and Engineering, Shimane University
資料タイプ
紀要論文
部局
(旧組織)大学院総合理工学研究科
備考
30-41+ / 1997-2007
このエントリーをはてなブックマークに追加