ダウンロード数 : ?
タイトルヨミ
ネジリ シケン ニヨル モクザイ ノ センダン ダンセイ ケイスウ ノ ソクテイ 2 ハバ ヘンドウホウ ノ ケントウ
日本語以外のタイトル
Measurement Method of the Shear Modulus of Wood by Torsion Test II. Examination of the Width-Variation Method
ファイル
言語
日本語
著者
内容記述(抄録等)
In this paper,the measurement method of shear moduli uslng the plural specimens with different aspect ratios,namely width-variation method,was examined by comparing the moduli obtained from the torsional moment-shear strains relations of single specimens.
Sitka spruce(Picea sitchensis Carr.)and konara(Japanese oak,Quenrcus serrata Murray)were used
for the specimens. Specimens were cut with various angles between the grain direction and an axis of geometrical symmetry,which was deined as‘grain angleφ”Specimens on which strain gauges were bonded were twisted around the radial direction. Shear moduli on the side planes were obtamed by the torsional moment shear strain relations and the torsional moment-torsional angle relations of plural specimens. These shear moduli obtained by the different procedures were compared with each other,and following results were obtained
(l)When the grain angle φ was in the range near around 45 degrees,the shear moduli were obtained properly by the both methods because the speicmen was nearly isotropic.
(2)When the grain angle φ approached to O degrees,the shear modulus of spruce was obtained properly. Nevertheless,the shear modulus of konara was not given by the width-variation method properly because the shear modulus on the plane with large stiffness varied by the variance of shear modulus on the plane with small stiffness.

掲載誌名
島根大学総合理工学部紀要. シリーズA
33
開始ページ
125
終了ページ
130
ISSN
13427113
発行日
1999-12-24
NCID
AA11157087
出版者
島根大学総合理工学部
出版者別表記
Interdisciplinary Faculty of Science and Engineering, Shimane University
資料タイプ
紀要論文
部局
(旧組織)大学院総合理工学研究科
備考
30-41+ / 1997-2007
他の一覧
このエントリーをはてなブックマークに追加