ダウンロード数 : ?
タイトルヨミ
サーメット セラミック CBN オヨビ ジンコウ ダイヤモンド コウグ ノ セッサク セイノウ ダイ2ホウ ダンゾク セッサク ニオケル マモウ トクセイ
日本語以外のタイトル
Cutting performance of Cermet, Ceramic, CBN, and Artificial Diamond Tools(2) : Wea from interrupted cutting of wood-based materials
ファイル
言語
日本語
著者
田中 千秋
中尾 哲也
高橋 徹
内容記述(抄録等)
This study was designed to investigate the possible use of cermets, cubic boron nitrides, ceramics, and artificlal diaminds for wood-cutting tools. The performance in wood cutting of tools was examined and oompared with cemented tungsten-carbide tools through observations of tool wear, and cutting noise in the interrupted turning of the core layer of particleboards. The amount of wear on clearance face, and noise level produced by turning for all tools investigated increase with the length of cut. The amount of wear was greatest on the ceramic tool which included zirconia as one of the components(Al2), greater on the ceramic tool which includes silica as one of the components(Al4) and on the ceramic tool(Al3)than that on the cemented tangusten-carbide tool, (WC) lower on the ceramic tool which included titanium-carbide as one of the oomponents(Al1) and on the cermet tool(TiN) than that on the cemented tangusten-carbide tool, and least on the cubic boron nitride(CBN) and artrificial diamond(D) tools for equal lengths of cut (Fig.3). The measured wear on the clearanceface in the interrupted turning was similar with that in the continuous turning(Fig.2 and 3). There was good correspondence between the amount of tool wear and noise level. It is expected that these materials will be used in practice as wood cutting tools when their cutting performance is considered alone.
掲載誌名
島根大学農学部研究報告
20
開始ページ
85
終了ページ
89
ISSN
0370940X
発行日
1986-12-20
NCID
AN00108015
出版者
島根大学農学部
出版者別表記
Shimane University, Faculty of Agriculture
資料タイプ
紀要論文
部局
生物資源科学部
他の一覧
このエントリーをはてなブックマークに追加